A valid FLARM Tool installation is required, see this article.
When FLARM Tool has detected the device, select FLARM->Settings.
Note the dialogue has two pages / tabs. When finished, click OK to save the settings to the device.
Articles in this section
- Workaround for invalid longitude values in "IGC Task Editor"
- How does Stealth Mode work? Who should use it?
- Why is my device not listed in the online configuration tool?
- How do I configure a device with SD card or USB port?
- How does the annual update cycle relate to the firmware expiration date?
- How to Recover a "Bricked" Classic FLARM?
- How do I know when there is a new firmware update?
- How do I Configure a Classic FLARM without an SD card slot?
- How do I update the Firmware on a Classic FLARM without an SD card slot?
Comments
0 comments
Please sign in to leave a comment.